10 Tips To Improve Baitcaster Casting Distance For Beginners

Anglers love to use baitcasting reels because it definitely has many advantages. However, many beginners are often quite confused when faced with the birdnest situations, tangles. They need to know about tips to improve baitcaster casting distance because they do not optimize their reels and technique to achieve the most extended distances when using baitcasting reels.

The best baitcasting reel can accurately present lures with a fishing rod and reel to a specific target area, have more line capacity, and use heavier lines. As with anything, developing consistently accurate casting, both long and short, takes practice many times. This means that many repetitions of proper form combine the rod and the reel with working in sync.

If you’re just a new angler who wants to use the best baitcasting reel or needs tweaking, you will lose the perfect fishing gear if you give up. Here are ten tips to improve baitcaster casting distance to help you use the reel better.

Related post: Best Baitcasting Reel For Beginners – Top 7 Beginner Baitcasters

Advantages Of Using Baitcaster

Provides smooth and unsurpassed casting control: easily adjust the spool speed with the thumb, gradually letting the lure fall to the right place.

Provides better line capacity: have more line capacity, use sustained lines, very suitable for long-distance fishing.

Provides superior traction: about 18lbs to 30lbs for catching big, fighting giant fish.

Compact and lightweight: they are 20% to 50% lighter than the reels and weigh around 4-6 pounds. This makes them perfect for anglers who spend all day long casting.

Have a line clicker sweet clicking noise when a fish hooks the lure and drags the fishing line.

Tip 1: Using Two Casting Techniques Correctly

The sidearm cast (or roll cast) and the overhead are two basic forward casts in fishing. The rolling cast provides better control and accuracy because of the lower trajectory. Besides there, the overhead cast provides maximum distance due to the higher launch angle.

The sidearm cast or roll cast begins with the casting hand palm-up on the back cast. During the forward cast, the wrists roll the hand into the palm-side position and launch at a low angle, just above the water. The 10 and 2 o’clock rules still apply, albeit in a horizontal plane. You still release your thumb at approximately 2 o’clock. However, for consistent accuracy, let the tip of the rod pass through and point straight at the intended target.

For best overhead casting, limit movement on the top of the rod from the 10 o’clock position on the back to the 2 o’clock position when releasing the spool with the thumb. Stopping the reciprocating movement of the casting at 2 o’clock rather than immediately dropping the rod into the water. Then, it keeps the rod in sync with the trajectory of the string as the lure reaches its apex.

This minimizes road friction in the guide rail, resulting in extra distance to the casting. When the lure is close to the water’s surface, you can slide the tip of the stick down to the 3 o’clock position to match the smoothing angle of the line. Also, keep your elbows, forearms, and rods relatively aligned for the most efficient transfer of force on release to improve baitcaster casting distance.

Tip 2: Don’t Fill The Spool When Casting

When practice to baitcaster, you can cast to the end of the spool without the same friction when filling the full spool. Having less line on the spool allows it to spin more freely, increasing its efficiency and getting more distance with the baitcaster. You also don’t get rubbed against the frame because it’s too full.

You must ensure enough lines for the long cast if it is a small spool. For example, if you are casting 60 yards, that minimum is 180 feet. It will be a long and healthy casting. So I started spooling the Baitcaster with fewer lines, not necessarily 250-yard filler. It will save money for you.

Tip 3: Use A Heavy Line And Braid As Backing

To make sure the lure doesn’t move faster than the spool after casting, this avoids a backslashing situation. It is recommended to use a heavier fishing line.

New anglers should have a line in the 14 to 18-lb test range. This is a normal casting distance with a baitcaster. That way, you can guarantee that the lure won’t travel faster than the spool, as the larger diameter of the line will make it a bit more slowly to release the spool. You’ll have more time to do thumb-braking and casting techniques.

A monofilament is better for new anglers using a baitcaster for the first time because it:

– Much cheaper than other fishing lines

– Very durable

– Easy to use

And if you prefer to use the backing (it is the line under your mainline, so you only have to replace small parts of the line). Braid might be a better choice to improve distance casting when you get used to the line. To increase the spool diameter without adding much, you can tie the line around the spool as tight as possible. Braid makes it more efficient and allows the spool to spin faster.

Tip 4: Match Rod Action To Lure Weight

If you’re throwing a heavier lure on a baitcaster, such as 3/4 ounce, you can load a stronger rod, like a medium-heavy rod, for extra spring when releasing. So powering up with heavier lures, turning around, and firing with more payload on the rod will launch your lures further.

If you cast a lighter lure with a baitcaster, you will get a longer distance casting by letting the rod load more into the casting back, and you need to reduce the power. So, if you want to throw the 1/4 or 3/8 oz lure further, go down a medium power rod from a medium-heavy power rod.

Tip 5: Make Your Casting Motion In The Right Way

Anglers who spend much time as hundreds of hours on the water each year experience forearm and elbow injuries if they are not casting the right technique.

After many years of fishing, I have experience gathering that by shortening your movement by keeping your elbows to the sides, you can more efficiently load and unload the rod to improve baitcaster casting distance, which creates inertia on the bait to give it the distance. Make the rod load and unload without swinging your arms forward and backward. Always straighten your arms partially. Keep your elbows bent and tight. Then, you can feel how much stronger the move and unmove rods are.

Then start the throwing motion and drop the lure precisely in the middle of the casting motion. Once the lure is flying, place your thumb on the spool to make sure that the lure doesn’t move faster than the spool spin.

Tip 6: Set Less Brake With Braid (Combine Fluoro Or Mono Line)

The braid is tighter and lighter on the spool. The diameter of this line is usually much smaller than that of monofilament or fluorocarbon. You can get out of the reel with less braking; it gives you longer distances and better efficiency. Turn down the brake with the braid and turn it up with the fluoro or mono line. In the end, you turn them all down to get the maximum distance.

Tip 7: Line Up Your Line Guide

The line guide is the narrow opening on most reels (the line comes off the spool and starts up your rod). If this passes one side or the other on the reel, it will cause additional friction to the casting. Make sure it’s centred when you click your thumb to cast. Then you’ll have less friction on the reel. This is a great tip to improve baitcaster casting distance.

Tip 8: Let Out More Lines To Improve Distance

A baitcaster can hold up to three times and sometimes four times as much as a spinning reel. It can accommodate extra lines without feeling more weight.

A longer line can give you more yards as you cast when using heavier lures. Thanks to this, experienced anglers are the reason they can troll big fish with a baitcasting reel than the average anglers when playing deep crankbait. They throw farther and more profoundly and stay in the attack cover longer per cast without the feeling of holding a heavier fishing rod during casting.

For other anglers in boats, trees on shore, etc., They can let 5-6 feet of line out on a casting and increase the load on the rod to let it release more on the casting for the same distance more than.

Tip 9: Practice Your Thumb To Brake

The simplest thing to increase your distance with baitcasters is to train your thumb to brake. You can then reduce tension and brake and have a more free-spinning hose. Start with a tense thumb push. The lure must not fall off the rod and slowly lower the pressure. When the lure starts to fall almost down, start training your thumbs.

Try to practice cast and controlling the spool with your thumb. At first, it won’t go very far. Let the spool spin under your thumb and maintain the feeling that no loops begin to form. That indicates that the spool is spinning faster than the lure when pulling the line away from the reel. That’s what causes backslash.

Let’s ease the tension more. Now you will have to type harder at the beginning of the casting. You still let the reel spin under your thumb, but you have to put in a bit more pressure because the spool’s starting inertia will be faster than at first, and the primer will pull the line away from the reel. With early pressure, you have to control that, then pull your thumb out as the lure gets further away from you. This will help you train your thumb.

Basically, your thumb is stiff at first. It is stiff than when you were in the cast. Do it again at the end of casting so that the lure falls into the water. Finally, it stops the line before the lure touches it.

Tip 10: Practice, Practice, And Practice

You should focus on the casting technique I mentioned and practice the above tips repeatedly to improve the baitcaster casting distance. As you start doing it repeatedly, you’ll quickly see how your casting abilities gradually improve. When mastering the casting, maximum control over the baitcaster distance can be achieved before hitting the water. Then you have become a professional angler. Keep practising, and don’t give up.

Baitcasting Reel Vs Spinning Reel

Many new anglers are confused about the difference between a baitcaster and a spinning reel. That’s why I listed a quick comparison between these two types of reels:


A baitcaster is placed above the fishing rod, while a spinning reel is placed at the bottom. Therefore, changing a spinning reel to a baitcaster will be inconvenient and take a while to get used to.

Casting performance

A baitcasting reel has a retrieve of long casting with a heavy lure that can cast with big ferocious fish. This type needs a lot of experience to be able to use it at its best.

A spinning reel often uses with a light lure for small and medium fishing applications. This type of reel is easy to use, does not require much skill, and is suitable for beginners.


A baitcasting reel is lighter than a spinning reel. In fact, it is known that reels are 20% to 50% lighter in weight than spinning reels. This is essential for anglers who often spend all day casting when using a baitcaster.


With more complex, durable components, a baitcaster tends to be 30% to 50% more expensive than a spinning reel. Namely, a baitcaster has:

– Lighter materials (usually carbon fibre) are more expensive

– Additional components (e.g. interrupts that automatically adjust spool speed to prevent backslashes)

– Intricate internal mechanism allows these reels to provide more drag


Baitcaster is more complicated to use than a spinning reel. When using a baitcaster, you have to pay more attention to dropping the lure. You must adjust the spool speed to ensure the lure falls into the water correctly. And the way you hold the rod and spin the reels is completely different from how you would do it with a spinning reel.

A right-handed reel means that you spin with your right hand, not that you hold the rod with your right hand. This is quite confusing if you are a new angler just used to handling a spinning reel.


When casting the lure, if not careful, the spool runs faster than the lure, and all the lines get stuck in the reel, which is called a “backslash”. This is very inconvenient and annoying for beginners who are used to spinning a baitcasting reel moving up and down. I like to adjust the spool speed with my thumb because it gives me more control over where the lure lands.

Line capacity

A baitcaster can hold more lines than a spinning reel with no feeling weight. Experienced anglers love this reel because they often cast at long distances to catch large fish without wanting to use a heavier rod.


After reading “10 Tips to Improve Baitcaster Distance For Beginner”, I hope you’ll start practicing to get more out of your casting reels. Don’t be discouraged if you’re starting out as a baitcaster. Practice a few times, and you’ll be the master of your next fishing trips.