How To Fix A Noisy Reel? (Detailed Guide For Beginner)

The most common cause of noisy fishing reels is a rubbing surface, internal clocking of the components inside the brake by replacing damaged rod ends and reel handles, or even disassembling the reels to clean or repair them. As a result, using the fishing reel makes noise. So, how to fix a noisy reel?

These noises are frequently caused by rubbing surfaces inside fishing reels; maybe the reel’s brakes are malfunctioning. The best way to avoid such a disaster is to keep your fishing reels as clean and light as possible. This article will provide additional information on permanently fixing a noisy reel. We’ve also included some other common issues that you might have with your fishing reels.

5 Causes Of Noisy Fishing Reel

A noisy fishing reel indicates an internal problem. You should inspect and try to fix it before purchasing a new one. Here are some causes of a noisy fishing reel and some solutions to the problem.

A Dry Reel Brake

The most common cause of a reel’s noise is the rubbing surface inside its body. This problem can be easily seen on many reels, especially on some reels that use centrifugal brakes made of plastic or fiber tabs.

How to fix it?

The best way to fix it is to oil the reel’s brake. Surfaces that are too dry will make a noise when rubbed. At worst, it can reduce casting distance. Therefore clean the brake with oil at least once a month to eliminate this problem.

A Dirty Fishing Reel

The second most common issue is a dirty reel. It not only generates loud noise but also affects the reel’s performance. Dirt in the reel parts can cause dryness leading to rubbing surfaces and causing the noise.

How to fix it?

Cleaning the inside of your reel at least once or twice a month is essential to ensure there is no dirt inside. Make sure to rinse with fresh water immediately after each fishing session.

The Reel’s Bearing Problem

A problem with the shaft’s bearings is it usually doesn’t make much noise for you to figure out. Check the bearings of the crankshaft to see if they are too loose or too tight, or check to make sure that the bearings are not putting too much pressure on them.

How to fix it?

The best way to ensure that bearings are no longer a problem is to apply lubricant. Then you need to ensure they are properly fitted to the reel. Too much or too little pressure can also lead to problems with the reel’s bearings.

A broken Spring

Sometimes you have to replace the spring of the crankshaft because it has been damaged and makes noise many times. Reeling, casting, and dragging performances will all be interrupted, so don’t hesitate to buy a new spring.

How to fix it?

Replace damaged parts as soon as possible. Grease gears are a good method.

Old Fishing Reels

Like many old types of machinery that make loud noises, old reels are no exception. They make noises to notify you that their mechanical and other components have reached their end of life.

How to fix it?

You can still use old fishing reels, but they must be cleaned and lubricated thoroughly for the machine to work properly. But an old reel can also affect its castability and overall performance, so don’t be afraid to buy a new reel instead if this situation recurs many times. I don’t think anyone wants an old fishing reel to be the source of a runaway fish.

Tips For How To Fix A Noisy Reel

Read The Manual

The instructions for the manufacturers’ reels are almost the same; the main difference is in the ability to lubricate and the type of oil or grease lubrication.

Lubricate Your Spindle Periodically

It would help if you lubricated the ball bearings at both ends of the spool shaft for at least a week.

Use The Correct Oil In The Right Amount And At The Right Frequency

Do not pour spray oil into grease-lubricated bearings or inside the shaft system. Do not pour thin oil into the gear system; it will wash off the grease on the surface and cause damage to the shaft.

Dilute oil will shorten the life of the bearings. Genuine oils are denser than spray oils but last longer on the bearings. Just a drop, or less, is fine for small ball bearings. Excess oil will go to other parts and damage them.

Dry The Reel After You Use It

If you drop a reel in water, it will mix with grease and cause a lot of trouble if you use it immediately. Dirt also damages the reels. Keep your reel clean.

If the reel falls on the sand and the handle does not rotate afterward, do not force the handle. The grains of sand are piling up between the gears, and you will damage both gears if you force it. Open the brake, then clean all internal components thoroughly.

Never Allow The Reel To Be Submerged In Water

Rinse the reel in flowing tap water after using saltwater or black water. Then dry it, and lubricate it. Wash thoroughly and lubricate with grease or solid oil; the bearing will die first.

Replace Parts That No Longer Work

Bearings and other components, such as spur gears, are designed to be replaced if necessary. With regular maintenance and replacement of worn parts of the reels, you save money without having to throw away and spend money buying a new reel.

Related post: How do I know if my reel and rod are balanced?

Why Is My Fishing Line Twisting?

The main cause of a twisted fishing line is that it is wound clockwise. You must set the spool counterclockwise to help control some line twists. Then combine the reel, and handle to maintain tension on the line and spool fill. Ensure you use the correct reel type for your line to avoid twisting.

How Often Should I Oil My Fishing Reel?

If possible, you should oil or lubricate your fishing reel at least twice a month. Just remember not to use too much oil on it. Or else, it will become over-lubricated, which can cause other problems, including noisy sounds. If the problem is with the bearings of the reel, oil them every two to three weeks to keep them running smoothly and in good condition.

Why Does My Fishing Reel Go Backward?

When the reel spins backward, it is most likely due to its malfunctioning anti-reverse feature. This feature keeps the reels from spinning backward and dragging with them. You need to check it before going to a service center for repair because sometimes doing it yourself can save a lot of money.

Conclusion

Noisy fishing reels are one of the most common problems you may encounter with your reels. It’s a pain if you’ve had it for a long time. Fear not because the above article has given methods and tips for how to fix a noisy reel. Immediately apply the above methods to have a great experience when fishing.

Read more:  Top 14 Best Baitcasters for the Money You Shouldn’t Miss